Drum -type rubber loading is a protective device commonly used in ships and dock projects, and some common problems may occur during the installation process. Here are some common problems and solutions.
1. Cracks appear on the surface of the rubber side:
Solution: First, check whether there is an excessive stretch of rubber -guarding side surface during the construction process. If so, stop stretching and reinstall it in time. Secondly, check the quality of the material of the rubber side. If it is a crack caused by quality problems, the material should be replaced.
2. Relax at the connection between the rubber side and the bracket:
Solution: Check whether the fixed bolt at the connection is firm. If the bolt is loose, it should be tightened in time. In addition, you can add tightness at the connection by adding rubber pads or pads.
3. Improper temperature control during the installation of rubber wares:
Solution: The temperature of the rubber side should be controlled according to the material requirements. Excessive temperature may cause rubber materials to deform, and too low temperatures may cause it to be unable to be fully installed during the construction process. Therefore, before construction, the temperature of the construction environment is required and ensured that construction is within the prescribed temperature range.
4. Rubber wares are damaged during transportation and installation:
Solution: In the process of transportation and installation, appropriate protection measures should be taken to avoid damage to rubber loom protection due to collision or other reasons. Especially before the rubber side installation is in place, protective measures should be taken to avoid damage to other engineering equipment.
5. Inaccurate installation position of rubber wares:
Solution: Before installation, carefully measure and calibrate the installation location according to specific requirements to ensure that the installation location is accurate. If there is a deviation in the installation position, adjust or replace the rubber side in time.
6. The fixed method of rubber wares is not applicable:
Solution: According to the specific construction environment and use requirements, choose the appropriate fixed method. In some cases, a special fixed fixture or bracket may be used to ensure that the rubber loading side can be firmly fixed in the required position.
7. The life of the rubber side is too short:
Solution: The service life of rubber wares is affected by various factors, including material quality, environmental conditions, and so on. Choose a rubber -loading material with good quality and suitable for the construction environment to extend the service life. In addition, regular inspections and maintenance of rubber fenders can also replace damaged parts in time, which can also extend their service life.
The above is some of the common problems and solutions during the construction of drum -type rubber loading. In actual construction, comprehensive consideration should be carried out according to the specific situation, and corresponding measures should be taken to ensure the installation quality and use effect of rubber wares.
Service Hotline:
13852402999
Company address:Central Avenue, Chengnan economic new district, Gaoyou City, Jiangsu Province
Company fax:0514-84617443
Company email:jssexj@jssexj.com